This pack contains 6 Dynamixel MX-106R actuators without accessories (screws, horn or cables) that can be purchased on this web site.
Horn and bearing set for Dynamixel actuators compatible with the Dynamixel RX-64 (N101 type) and EX-106+.
Use this pack of five 3P-Sync 160 mm cables for connecting two Dynamixel MX-106 and X540 servos in master/slave mode.
Horn and Bearing set for Dynamixel compatible with RX-24F and RX-28 actuators.
This pack of four 5P cables (150 mm) from Robotis makes it easy to connect your robot sensors.
Horn and bearing set for Dynamixel actuators compatible with the RX-24F, RX-28 and MX-28 actuators.
This pack of ten 180 mm X4P cables (convertible) is to be used with Dynamixel X-series servo motors with an RS485 interface.
Frame for Dynamixel actuators EX-106+ and MX-106 to control then in dual mode (two synchronized Dynamixel actuators that are controlled simultaneously in a parallel to increase the torque).
Pack of 10 TTL communication cables for the Dynamixel X-series servomotors.
Horn, black frame and bearing set for Dynamixel EX-106+ and MX-106 actuators
The X4P 100 mm cable is designed especially for connecting your Dynamixel XM-430 servos quickly and efficiently. You’ll find it hard to do without this Robotis cable!
Frame to connect 2 Dynamixel EX-106+ or MX-106 in dual mode.
This pack of medium-length X4P cables for Dynamixel XM-430 offers greater flexibility in terms of wiring.
Black frame to connect 2 Dynamixel EX-106+ or MX-106 in dual mode.
Precision navigation, increased autonomy and varied operating modes: the SyRen 10 motor driver is one of the most efficient for medium-sized robots.
With this pack of X4P 240 mm cables, you get 10 4-pin Dynamixel cables of the highest quality to connect your XM-430 Dynamixel servos.
35cm long cable for Dynamixel X-series servo motors, TTL protocol.
The famous SyRen regenerative motor driver is returning in a 25A version: fully secured and highly versatile, it gives you extended control over your robot’s movements.
In this set, you’ll find 10 sturdy plastic structural components for Dynamixel AX servo motors, suitable for replacing components in Bioloid robots.
Dynamixel X-series compatible cable (TTL), length 50 cm.
Put the SyRen 50 motor driver to the test: up to 100A peak, 4 operating modes for controlling velocity or direction, and 100% safe.
This set of 10 FP04-F3 side mounting frames is designed for the Bioloid robotics kits by Robotis that use the AX series Dynamixel servomotors.
This 4-pin extension cable is 1 metre long and compatible with the servo motors in the Dynamixel XW series.