The MX-106R is a Dynamixel servomotor, with high-level control features and very precise. It is by far the most powerful of the Dynamixel servomotors.
10 cables (20cm lenght) with 4 pin connectors for the Dynamixel servomotors of the DX, RX and EX series.
The 4P JST Expansion Board is an extension board that allows you to add additional features to your robot.
The Dynamixel XH540-V270-R servo motor is equipped with an RS485 interface and offers a 272.5:1 reduction ratio. It’s fully programmable, and with 6 various control modes available, it is suitable for many applications and configurations.
Use the proper bolts for fixing your Dynamixel servos!
Probably one of the best drivers in its class – the Sabertooth 2x 25 A Motor Driver is powerful, versatile, extremely reliable and allows you to control 2 motors at once while recharging your supply batteries!
Pack of 6 Dynamixel MX-28T servomotors
5 cables (15cm length) For 3P-5P conversion
Mechanical set for Dynamixel RX-24F, RX-28 and MX-28 actuators
This metal gear set is designed to last longer and resist abrasion. The gears are compatible with all servo motors in the Dynamixel X540-150 series with a TTL or RS-485 connection.
The BNS-30 bolt/nut set for Dynamixel AX-series servos includes 70 tapping screws and can be used as an add-on to your BNS-10 set.
Sabertooth 2x32 is a dual channel motor driver capable of supplying 32A to two motors–with peak currents up to 64A. It can be operated from radio control, analogue, TTL serial or USB inputs. It uses regenerative drive and will boost your robot!
This pack of 6 Dynamixel MX-28R servo motors is just the right choice for conceiving a mobile robot or any other project drawing on Dynamixel’s expertise: a servo including a gear system, a driver and a controller. The MX-28R is an efficiently designed servo with high performance actuators and communicating via an RS485 interface.
This 3P Cable Set for Dynamixel servo motors in the AX and MX series lets you make all the standard connections between your robot and the various sensors and actuators that it needs.
This gear set is designed to replace the gear parts on the X540 servo motors equipped with a reduction ratio of 270:1.
A set of 50 Bolt PHS M2x10 screws for mounting your Dynamixel servomotors.
The Sabertooth family is back with its most ambitious motor driver: 2 x 60A for controlling robots up to 450 kg with the necessary sensitivity!
Robotis put together this pack of 20 FP04-F55 Dynamixel Cable Holders to more efficiently organise Bioloid robot cables.
Pack of 6 Dynamixel MX-28AT actuators without any accessories
Set with frame, horn and bearing for Dynamixel actuators
The Dynamixel communication bridge is designed to convert the RS485 or TTL signals from your servo motors into a single signal for analysis on your computer.